Constant temperature water bath

  Constant temperature water bath is one of the most common constant temperature baths. It is widely used for constant temperature, evaporation, drying, concentration, constant temperature, heating, chemical reaction, biological drug reaction, etc. of enterprises, medical institutions, universities, scientific research departments and production units. Temperature test and other occasions.

  The constant temperature water bath has a horizontally placed stainless steel tubular heater. Inside the sink, there is an aluminum shelf with holes. The upper cover is equipped with a combination of different diameter ferrules, which can be adapted to different diameter flasks, beakers and other containers. There is a water discharge hose on the left or rear of the water bath, the right side of the constant temperature water bath is the electric box, the front panel of the electric box is equipped with temperature control instruments and power switches, and the electric box has electric heating tubes, sensors, transformers, etc.

  1. The shell is made of high-quality steel plate, and the surface is sprayed with plastic, which is beautiful and generous.

  2. The inner tank is made of stainless steel plate with good corrosion resistance;

  3. The temperature control system uses high-precision sensors and integrated components, and the digital tube display makes the temperature control accurate and reliable.

Constant temperature water bath

Instructions

  1. When using it, warm water must be added to shorten the heating time and save electricity.

  2. Turn on the power switch, the power indicator light is on to indicate that the power is on.

  3. Set the meter to the required temperature. The heating indicator light indicates that the power of the electric heating tube is turned on for heating. When the temperature on the thermometer reaches the required temperature, wait a few minutes, the automatic thermostatic control.

  4. The scale of the thermostatic controller is only used for temperature control indication, not temperature indication scale.

Precautions

  1. The enclosure of the box must be effectively grounded.

  2. Before adding water, do not turn on the power to prevent the hot wire of the electric heating tube from burning.

  3. Do not disassemble the difference plate on the right side for safety unless it is necessary.

Maintenance and repair:

  1. Turn off the power after use.

  2. Keep the inside and outside of the box clean and tidy.

  3. If it is found that the instruction light is not on, turn off the power first, remove the plug and disconnect the right side board. If the fuse or indicator bulb is damaged, it can be replaced with the same specifications.

  4. In case of failure of constant temperature control, it means that the sensor on the controller is out of order and can be used after replacement